RGB Monitor's Rumored to work with a TI 80col device or Geneve
This list compled from list server messages and personel experiance
NEC Multisysnc I or II
NEC 3D
KODAK SV1310
Tuner service of Rochester, 716/429/6880
Amiga, 1080, 13", 0.42
Most all amiga monitors will work
Magnavox Professional RGB Monitor 80
Magnavox, 1CM135, 14"
Magnavox, 8CM515, 14"
Magnavox, 8CM536, 14"
Sony, CDP-9000, 10", 0.25 dpi,
Sony, CDP-1201, 13", 0.25 dpi,
Sony, KV-1311CR, 13", 0.37 dpi
Teknika, MJ-305, 13", 0.41 dpi,
Torino, Vidi Ad, 14", 0.42
Thomson, 4120, 14", 0.42 dpi
Thomson, 4160, 14", 0.38 dpi
NANAO (Japanese) 8060H, 14", Analog/TTL,
Multiple scan freq between 15.75 KHz and 35KHz
Commodore 1084
Of course the larger size and smaller dot pitch
the better
I have several of the Magnavox monitors as well as several others
that I
keep for spares. I will not hook one up to my Geneve or TI 80col
system
again unless my NEC's die. the Magnavox are all .41 to .51 dp and
look
pretty crappy after looking at a 17" .25 dp SVGA monitor at
work
The NEC's are either .28 or .31 and look much better. They dont
seem to flicker
as bad in Interlace mode either. You can find them on ebay from
1-50 bucks my
best one cost 6.00 NEC MultiSync I or II work no problems I have
a NEC
MultiSync 3d that should work but I haven't deciphered the cable
yet.
NEC II Pin Specs
NEC II jc-1402hma pin specs right off their web
site. Keep in mind I am
wired to a Mechatronics side car and EVPC your specs may vary
Manual switch on
NEC ---------------- TI
1 -------------------- 3 ----------red
2 -------------------- 4 & 8 -----Green / Sync on green
3 -------------------- 5 Blue
4/5 -------------------nc
6,7,8,9 ---------------Ground
MultiSync II JC-1402HMA
Analog - Composite Sync
MANUAL SWITCH ON
NAME - ## - Description of each pin and/or jumper
01--------------- Red
02--------------- Green also Composite Sync
03 ---------------Blue
04 ---------------H/V Sync No Connection
05 -------------- Mode Control No Connection
06 --------------Ground
07 --------------Ground
08 --------------Ground
09 --------------Ground
TIM PIN OUTS
NAME - ## - Description of each pin and/or jumper
PI
11 ---- CSYNC Composite SYNC output (used in RGB monitor
hook-ups)
13 ---- GROUND Logic/Signal/Chassis Ground
22 ---- BLUE (Analog blue control for RGB monitor)
23 ---- RED (Analog red control for RGB monitor)
24 ---- GREEN (Analog green control for RGB monitor)
25 ---- GROUND Logic/Signal/Chassis Ground
KODAK to TIM
2 ------------25
3 ------------23
4 ------------24
5 ------------22
7 ------------11
A Couple of Links on RGB Monitor's
http://www.gamesx.com/misctech/rgbprimer.htm
http://www.gamesx.com/misctech/lm1881.htm